[عمران وقاد]

Flashing :
a ROM is the process putting a new ROM on your device or otherwise know as upgrading.

Hard Reset :
Switch the device off. Press and hold the Left SOFT KEY and Right SOFT KEY, and at the same time, use the stylus to press the RESET button at the bottom of your device. You will be presented with a menu saying ‘press R to reset, X to exit’. If you press R, your device will be set back to factory default settings. Hard Reset will delete all data you have put on the device: Programs, Settings, Mail, SMS, MMS, etc., so be careful and make a backup before doing this. After a hard reset, you will have a complete clean new install of Windows Mobile on your device. Data on \Storage Card & \Extended_Rom folder will not be deleted

HardSPL :
This modified bootloader (by Olipro) allows a much safer flashing process to take place since it reduces the chance of permenently bricking your Hermes device. It also removes the need to CID Unlock the device since it ALWAYS reports SuperCID when flashing.

IPL:
Initial Program Loader - It boots up SPL. Its the bootloader for PPC, much like the BIOS is the boot loader for your PC. Note: IPL/SPL are highly hardware dependent, flashing the wrong IPL/SPL is much more serious than a flashing the wrong ROM. It may be noted that, sometimes a ROM package also contains the IPL/SPL which will be flashed into your phone. Hence be extra careful what you are flashing. Note: although a ROM may also contains the IPL/SPL

OEM :
Original Equipment Manufacturer - is a company that supplied equipment to other companies to resell or incorporate into another product using the reseller’s brand name.

OS:
Operating System - the platform software for your phone, much like the Windows Xp/Vista for your PC. Upgrading the OS is like, in PC terms upgrading from Windows XP to Windows Vista. Os for PPC are WM2002, WM 2003, WM2003SE, WM5, WM6

PIE :
Pocket Internet Explorer - is the default browser that comes with the Windows Mobile Operating System.

PPC :
Pocket PC - is a hardware specification for a Personal digital assistant that runs the Microsoft Windows Mobile operating system.

Program memory: The non-persistent memory part of WM5, which is used for all the temporary memory requirements, much like the RAM of your PC. A soft-reset or flat battery will erase everything from the program memory. You can’t adjust the ratio of Storage memory and Program memory in WM5 like WinCE2003.

Radio:
commonly used in the form `upgrading the Radio/GSM` - in the field of ROM upgrading. The `Radio` is essentially a ROM that controls the phone function part (as oppose to PDA function part) of your phone. Upgrading this `Radio` software may have effect on your phone reception quality, battery life (optimized phone function), signal strength, etc.

RIL:
Radio Interface Layer -

ROM:
Read Only Memory - commonly used in the form of `ROM upgrade`. The ROM is the firmware/software, which controls everything on your phone. ROM itself usually comes in a package, with IPL/SPL, OS, Radio, and ExtRom. However, in most cases, `upgrading a ROM` usually means just the OS and the ExtRom, as these are the obvious/visible part of an ROM upgrade.

RTM :
Release to Manufacturing or Ready to Market.

RUU:
ROM Upgrade Utility - Its the s/w used on your PC to do a ROM upgrade for your PPC

SIM:
Subscriber Identity Module - commonly used in the form `SIM unlock`. Some phones are locked to the specific telco from which you purchase your phone, eg you can’t use a locked 3Mobile phone with a Vodaphone SIM/smart card. To use SIM card from other telco, you need to SIM unlock your phone. Note: In general, the phrase ‘unlock your phone’ usually refers to SIM-unlock, not CID unlock.SIM Unlock: Use any carrier’s SIM in the device.

SIP :
Software Input Panel - for devices that does not have a hardware keyboard the SIP is used to enter data on to the PPC eg: the software keyboard, Symbol Pad, Block Recoganizer, etc . Note : SIP can also stand for Session Initiation Protocol , check the wikipedia entry SIP as a voice over IP protocol.

Smartphone :
Pre WM6 class, Smartphone is defined as a mobile phone which offers advanced capabilities like that of a PC. It will not have a touchscreen as compared to a Pocket PC. With the introduction of WM6 all mobile phone devices running Windows Mobile are no cl***** as Windows Mobile powered Smartphones